The temperature coefficient is not a secondary parameter when it comes to choosing a photovoltaic module. Let us tell you why.
Preliminary remarks
The temperature coefficient affects the performance of photovoltaic panels.Photovoltaic panels are made of crystalline silicon, that’s why the higher the temperature, the lower the performance. This is an intrinsic property of the silicon. Think about the fans of your computer. They cool down the silicon chips to make them work more efficiently.
In photovoltaic panels, power decreases because the cell’s voltage decreases. This happens even though the produced current increases. In fact, this increase does not compensate voltage dips. That’s why we have an overall decrease in power.
What is the average temperature, under real conditions, with which a photovoltaic module runs?
International technical standards force us to measure and classify the module at a standard temperature of 25 °C. However, most of the times, this value is lower than the module’s real temperature conditions. Often, the module runs at 20-30 °C higher than the environmental temperature. During summer, temperatures can reach or even exceed 60 or 70 °C.
The average operating temperature is about 50 °C, meaning 25 °C more than the reference conditions. Two modules, which are normally labelled with the same power but with a different temperature coefficient, will produce different powers.
The temperature coefficient is the parameter we need to calculate this loss, and it usually ranges between -0.29 and -0.5 %/°C. This means that every 10 °C in excess results in a decrease in power of the module ranging between 2,9 and 5%.
So?
This parameter must be taken into account when choosing a module to optimise the annual yield!
That’s why FuturaSun has always been committed to increasing the temperature coefficient of its modules. At the same time, we have been able to reduce the operating temperature while maintaining electrical insulation characteristics unaltered. Optimisations on glass, working wavelength of the front and rear E.V.A. (ethylene vinyl acetate) sheet, and on the backsheet surface.
⇒ Our temperature coefficients have been measured by TÜV Rheinland and Dekra and are among the best in the industry: – 0.29 %/C° for IBC ZEBRA panels and -0.35%°C for polycrystalline photovoltaic panels
Our thermal coefficients have been measured by Tüv Rheinland and DEKRA and are among the best in the industry: – 0.29 %/C° for IBC ZEBRA panels and -0.35%°C for monocrystalline modules.

What we recommend is to always spend some time
to find the temperature coefficient before choosing a module.
Below is the item in our technical sheets (photo)
Nicola Baggio
He graduated in Aerospace Engineering. He has 13 years of experience in photovoltaic sector, in particular in module production, certification and technical testing.









